Verify a lot
Every vial carries a lot number. When a third-party certificate exists for a lot, this is where you will read it. We do not have them yet — the records below demonstrate the format and are labelled as such.
READING A CERTIFICATE
Four checks, in this order.
A certificate of analysis is only worth what you can verify on it. Most of the bad ones fail at step one or step four.
The lot number matches your vial
Not the product, the lot. A certificate for a different batch of the same compound tells you nothing about the powder in your hand. If a supplier shows one COA for every unit they've ever sold, that's a brochure, not an assay.
Identity, by mass spectrometry
The observed mass should sit within a few daltons of the compound's published molecular weight. This is the check that catches the wrong peptide entirely — and it's why the molecular masses in our compound reference exist.
Purity, by HPLC, as area percent
Reported as the area of the main peak against total peak area. A figure without a method beside it is a claim rather than a measurement. Watch for purity quoted without specifying RP-HPLC, and for certificates that show a number but no chromatogram.
Internal consistency
The most common tell. Check the stated molecular weight against the stated molecular formula — they have to agree. Certificates circulate in this industry with a formula from one peptide and a mass from another, because the template was copied and half the fields were never updated. If those two disagree, nothing else on the page is trustworthy either.
Certificates record what a laboratory measured about a batch of material. They are not approvals, and they say nothing about safety or suitability for use in humans or animals. All compounds are supplied strictly for laboratory research — not drugs, foods, cosmetics or supplements, and not for diagnosis, treatment, cure or prevention of any condition.